Ntp not updating cisco
Many networkers underestimate the importance of keeping accurate time on all devices across a network.
This is particularly true among smaller companies without strong IT policies.
To configure "Omni Secu R1" as the NTP Time server, follow these steps.H [[email protected]: Active] config # tcpdump udp port 123 tcpdump: WARNING: eth0: no IPv4 address assigned tcpdump: verbose output suppressed, use -v or -vv for full protocol decode listening on eth0, link-type EN10MB (Ethernet), capture size 108 bytes .201229 IP ACC-GTM-01. In a network, if all the devices are not connected to internet directly, we can configure a Router (which is connected to internet) to synchronize its time from Public NTP Time Servers and remaining devices to syncronize from the first Router.In this case there, the LTM can reach the NTP server either through the management interface (.10) or production traffic interface ( .30), as access had bin allowed on the firewall. I cant see the NTP traffic from the LTM when I view the live log on FWSM What interface by default will the LTM use to communicate with the NTP server. which I've seen a couple of units do for unexplained reasons.I have define route to the NTP server through this two interfaces, yet its not working. Login to the cli and type ntpq -p and examine the output. Just do a quick 'bigstart restart ntpd' and that'll restart ntpd and cause it to try & talk to the upstream ntp servers you've defined.